Export Norxe Unify
The Norxe Unify exporter supports export and upload of warping, blending and black level correction for Norxe Unify projectors.
Requires Firmware 1.3 or newer.
Black Level Correction not yet tested.
Export Settings
- Export Path
Before the correction data can be uploaded it has to be saved locally to the computer. The export folder should exist. All data necessary for the upload will be saved there.
- Scaling
Select how non-native content is scaled. Activate letterboxing, when ”Fill Aspect” is used on projector
- Native Resolution
Set the native projector chip width and hight here (depends on projector type). This is important to do the correct scaling of the exports.
- Shading
Select which layers should be included in the exported shading file.
- Black Level Correction
Select if black level correction should be exported as well.
- Upload Name
Allows to use custom names for the uploaded correction file. Thus multiple corrections can be stored on the projector for different scenarios.
- Table with IP-addresses
Enter the ip address of each projector, so that export can be directly uploaded. If a projector is unchecked it will be excluded from the direct upload.